Here are the answers to Thursday's Cisco certification exam practice questions!
CCNA Certification:
Host A and Host B are in the same VLAN. Host C and Host D are in a different VLAN. Host A sends a broadcast. How many other hosts will receive it?
A. Zero
B. One
C. Two
D. Three
Answer: B. The other host in the same VLAN, Host B, will receive it. Broadcasts are not forwarded to other VLANs.
CCNP Certification / BSCI Exam:
If an IPv6 address begins with "FF", what type of address is it?
A. broadcast
B. unicast
C. multicast
D. MACcast
Answer: C. That's a multicast. There's no such thing as a MACcast. But there should be. ;)
CCNP Certification / BCMSN Exam:
Short answer: What interface-level command takes a port operating at L3 and places it into L2 operating mode?
Answer: switchport. To change the port back to a routed port, use no switchport.
CCNP Certification / ISCW Exam:
Short answer: You're going to write a policy map that will be applied to a Serial interface running at T1 speed. By default, how much bandwidth can you assign in that policy?
Answer: The speed of a T1 line is 1544 kbps, but by default only 75% of that bandwidth can be distributed in a policy map - that's 1158 kbps (1544 * .75).
New questions and a new BCMSN tutorial will be posted later today!
To your certification exam success,
Chris Bryant
CCIE #12933
http://www.thebryantadvantage.com
CCNA Certification:
Host A and Host B are in the same VLAN. Host C and Host D are in a different VLAN. Host A sends a broadcast. How many other hosts will receive it?
A. Zero
B. One
C. Two
D. Three
Answer: B. The other host in the same VLAN, Host B, will receive it. Broadcasts are not forwarded to other VLANs.
CCNP Certification / BSCI Exam:
If an IPv6 address begins with "FF", what type of address is it?
A. broadcast
B. unicast
C. multicast
D. MACcast
Answer: C. That's a multicast. There's no such thing as a MACcast. But there should be. ;)
CCNP Certification / BCMSN Exam:
Short answer: What interface-level command takes a port operating at L3 and places it into L2 operating mode?
Answer: switchport. To change the port back to a routed port, use no switchport.
CCNP Certification / ISCW Exam:
Short answer: You're going to write a policy map that will be applied to a Serial interface running at T1 speed. By default, how much bandwidth can you assign in that policy?
Answer: The speed of a T1 line is 1544 kbps, but by default only 75% of that bandwidth can be distributed in a policy map - that's 1158 kbps (1544 * .75).
New questions and a new BCMSN tutorial will be posted later today!
To your certification exam success,
Chris Bryant
CCIE #12933
http://www.thebryantadvantage.com
Comments