Welcome back! It's Tuesday, September 30, and here are the answers to the Cisco certification exam training questions posted on Monday!

CCNA Certification And CCENT Certification:

Short answer: What command resulted in the following output?

R3# ?
HD unit 1, idb = 0x1C44E8, driver structure at 0x1CBAC8
buffer size 1524 HD unit 1, V.35 DCE cable

Answer: That's the output of show controller serial x. The above content is followed by about 25 lines of hex, but the DTE/DCE cable information you see there is (thankfully) near the top!




CCNA Security Certification / CCNP ISCW Exam:

Short answer: "All" is one of the SDEE Message display options available in SDM. Name the other three.

Answer: error, status, and alerts.


CCNP Certification / BSCI Exam:

Is the following configuration legal? If so, what's the meaning of the third line?

R2(config)#route-map PASSBSCI permit 20
R2(config-route-map)#match ip address 23
R2(config-route-map)#set interface serial0 ethernet0

Answer: Yes, this configuration is legal! When you name two interfaces with the set interface command in a route map, the first interface will be used as long as it's available, with the second interface being put into use only if the first interface is unavailable.



CCNP Certification / BCMSN Exam:


Port security can't be used with which of the following?

A. trunk ports

B. Etherchannel ports

C. destination SPAN port

D. 802.1x ports

Answer: A, B, C, D. You can't configure port security on any of those port types.



CCNP / ONT Exam:

Give both the numeric and non-numeric name and value for the highest level of IP Precedence available in the following configuration.

R2(config-pmap-c)#set precedence ?

Answer: Numerically, it's 7, the network level.

I'll have new practice exam questions for you later today!

To your success,

Chris Bryant
CCIE #12933
http://www.thebryantadvantage.com/