Here are your free Cisco and CompTIA questions for Wednesday, February 6!
CCNA Certification:
What character or combination of characters indicates a statically configured default route?
Cisco CCENT / Network+ Certification Question:
Which one of the following networking terms is not associated with the same OSI layer as the others?
A. router
B. packet
C. TCP
D. IP
Security+ Certification:
What's the difference between a stateful and stateless network layer firewall?
CCNP Certification / BSCI Exam:
If an IPv6 address begins with "FF", what kind of address is it?
A. broadcast
B. unicast
C. anycast
D. multicast
CCNP Certification / BCMSN Exam:
You've configured an Etherchannel and note that the trunk has gone down. You check the interfaces on one switch and note that two are "err-disabled". The corresponding ports on the other switch are not. What should you do?
A. Nothing - that's the normal and desired behavior.
B. Shut and reopen the err-disabled interfaces.
C. Shut and reopen the non-err-disabled interfaces.
D. Use the err-abled command on the err-disabled interfaces.
Answers will be posted Thursday, February 7!
To your success,
Chris Bryant
CCIE #12933
http://www.thebryantadvantage.com/
CCNA Certification:
What character or combination of characters indicates a statically configured default route?
Cisco CCENT / Network+ Certification Question:
Which one of the following networking terms is not associated with the same OSI layer as the others?
A. router
B. packet
C. TCP
D. IP
Security+ Certification:
What's the difference between a stateful and stateless network layer firewall?
CCNP Certification / BSCI Exam:
If an IPv6 address begins with "FF", what kind of address is it?
A. broadcast
B. unicast
C. anycast
D. multicast
CCNP Certification / BCMSN Exam:
You've configured an Etherchannel and note that the trunk has gone down. You check the interfaces on one switch and note that two are "err-disabled". The corresponding ports on the other switch are not. What should you do?
A. Nothing - that's the normal and desired behavior.
B. Shut and reopen the err-disabled interfaces.
C. Shut and reopen the non-err-disabled interfaces.
D. Use the err-abled command on the err-disabled interfaces.
Answers will be posted Thursday, February 7!
To your success,
Chris Bryant
CCIE #12933
http://www.thebryantadvantage.com/
Comments