It's Monday, November 24, and here are the answers to Saturday's Cisco practice exam questions!
Name the two possible values for "destination" in an ip route command.
A. The local exit interface's name
B. The local exit interface's IP address
C. The next-hop IP address
D. The interface upon which the destination will receive the packet
Answers: A, C. You can specify either the name of the local interface or the next-hop IP address.
Which of the following can you configure in the Additional Tasks section of SDM?
A. VTY line security
B. A local username/password database
C. DHCP pools and bindings
D. Security audits
Answer: A, B, C. To run a security audit, click the Intrusion Prevention task button.
Short answer: What purpose does the as-set command serve in BGP?
Answer: This is an option in BGP route aggregation. If you use the as-set option, the path advertised for the aggregate route will be an AS_PATH that was traveled by all of the more-specific paths being aggregated. Cisco recommends that you do not use this option when a great number of paths are being aggregated, since the aggregate may be removed, updated, and replaced as AS-path reachability changes.
CCNP Certification / BCMSN Exam:
What command would verify the port security settings on interface fast 0/2?
SW1#show port-security interface fast 0/2
Port Security : Enabled
Port Status : Secure-up
Violation Mode : Shutdown
Aging Time : 0 mins
Aging Type : Absolute
SecureStatic Address Aging : Disabled
Maximum MAC Addresses : 3
Total MAC Addresses : 2
Configured MAC Addresses : 2
Sticky MAC Addresses : 0
Last Source Address:Vlan : 0000.0000.0000:0
Security Violation Count : 0
Name the overall phases of converting an analog signal to a digital signal.
Answer: sample, quantize, encode, compress .
More questions later today, and be sure to check the recent blog posts for brand-new CCNA and CCNP training videos!
To your success,