CCNA Security tutorials and practice exams will be posted 5 - 7 times per week beginning today!
Let's take a look at today's questions! All of today's questions are short answer.
CCNA Certification And CCENT Certification:
Write a configuration that would allow the following three users to successfully telnet in with the appropriate access level. Their first name is their username, last name is their password. (Don't do this at work! :) ) Include any necessary line configuration.
Jack Trump - highest privilege level possible
Donald Canfield - lowest privilege level possible
Stacy Putty - higher than Canfield, but lower than Trump
What happens if you start the WCS service and it's already running? Discuss any potential issues that could arise from this situation.
You're running cRTP, and UDP checksums are not in use. What is the approximate compression percentage of the IP, UDP, and RTP headers?
CCNP Certification / BSCI Exam:
What is the net effect of the following configuration? Are there options for this command that should be considered?
R1(config)#router ospf 1
CCNP Certification / BCMSN Exam:
What should you do to avoid the error message shown below?
SW2(config)#int fast 0/8
Command rejected: Conflict between 'nonegotiate' and 'dynamic' status.
What options will IOS Help show in the following configuration?
R1(config)#int tunnel 0
R1(config-if)#ip address 192.168.1.1 255.255.255.0
R1(config-if)#tunnel source 10.1.1.1
R1(config-if)#tunnel destination ?
I'll post the answers on Thursday, September 4! In the meantime, head over to my Cisco CCNA And CCNP Tutorial Page - over 200 free tutorials, articles, and practice exams await you!