Saturday, September 20, 2008

It's Saturday, September 20, and here are your Cisco certification exam training questions for today!

CCNA Certification And CCENT Certification:

Take a look at the following configuration and answer these questions:

1. What's the escape sequence mentioned in the first line?

2. What two commands combined to create this output?

3. What is a more common name for "ICMP Echos"?

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to, timeout is 2 seconds:
Success rate is 100 percent (5/5), round-trip min/avg/max = 136/139/152 ms
IP: s= (local), d= (Serial0), len 100, sending
IP: s= (Serial0), d= (Serial0), len 56, rcvd 3
IP: s= (Serial0), d= (Serial0), len 100, rcvd 3
IP: s= (local), d= (Serial0), len 100, sending

CCNA Security Certification / CCNP ISCW Exam:

Which of the following does IKE *not* negotiate?

A. IKE keys

B. IPSec Security Agreements

C. QM_IDLE mode (Tunnel or Transport)

D. authentication of IPSec peers

CCNA Wireless:

Define the term modulation, and discuss briefly what the term means in today's wireless networks.

CCNA Voice:

Which of the following is *not* a VoIP signaling protocol?






CCNP Certification / BSCI Exam:

What message should you expect the router to display immediately after entering the following configuration?

R1(config)#router ospf 1

R1(config-router)#redistribute connected

CCNP Certification / BCMSN Exam:

What command resulted in the output shown below?

SW1# ?
Session 1
Type : Local Session
Source Ports :
Both : Fa0/1-5
Destination Ports : Fa0/6
Encapsulation : Native
Ingress: Disabled

CCNP / ONT Exam:

Name the three drop behaviors that RED can carry out.

I'll have the answers right here for you on Sunday, September 21!

To your success,

Chris Bryant
CCIE #12933

No comments:

Blog Archive