Welcome! Here are your free CCENT, CCNA, and CCNP certification exam training questions for Thursday, October 11!

All questions today are short answer.


CCENT Certification:

If you see the following in the output of show interface serial0, what is most likely the issue?

interface is up, line protocol is down

A. The cable is loose.

B. The interface is shut.

C. There is a clocking issue.

D. There is no IP address configured on the interface.

Don't forget - it's only 11 days until the release of my Ultimate CCENT Study Package! Reserve your copy today and get FREE CCNA training in November!



CCNA Certification:

On the blank console line shown below, what command should be used to prevent OSPF hellos from keeping the ISDN line up?

R2#conf t
Enter configuration commands, one per line. End with CNTL/Z.
R2(config)#interface bri0
R2(config-if)#



CCNP Certification / BSCI Exam:

By default, how does an OSPF routing table indicate routes that were learned by the OSPF domain via redistribution?


CCNP Certification / BCMSN Exam:

A switch has two paths to the root bridge. One is direct, the other goes through another switch. You want to lessen the delay that will occur if the current root port goes down. What Cisco feature can help?


CCNP Certification / ISCW Exam:

Users who telnet successfully into your router should be placed directly into privileged exec mode. What command will accomplish this?


CCNP Certification / ONT Exam:

You're working with a serial interface set to T1 speed. By default, what queueing scheme is running on that interface?


Answers will be posted Friday!

To your success,

Chris Bryant
CCIE #12933
http://www.thebryantadvantage.com/

Comments

Popular posts from this blog